• 设为首页
  • 加入收藏
  • 联系邮箱
  • 网站首页
  • 期刊介绍
    • 期刊简介
    • 历任主编
    • 期刊荣誉
  • 编委会
    • 社长及主编
    • 主任委员
    • 编委名单
  • 投稿指南
    • 作者须知
    • 投稿步骤
    • 范文(规范细则)
    • 稿件处理流程
    • 著作权转让协议
  • 期刊影响力
  • 开放获取
  • 出版道德政策
    • 出版伦理声明
    • 学术不端认定和处理方法
    • 广告及市场推广
    • 同行评议流程
    • 斟误和撤回
    • 回避制度
    • 文章署名及版权转让
  • 历年目次
  • 联系我们
  • English
站内检索    
 
王荣军.G3-PLC系统定时同步-信道估计联合设计与实现[J].电测与仪表,2014,51(10):.
wang rongjun.Combined Design and Realization of Timing Synchronization and Channel Estimation for G3-PLC System[J].Electrical Measurement & Instrumentation,2014,51(10):.
G3-PLC系统定时同步-信道估计联合设计与实现
Combined Design and Realization of Timing Synchronization and Channel Estimation for G3-PLC System
DOI:
中文关键词:  G3标准  OFDM  定时同步  互相关算法  信道估计  CELENEC频段
英文关键词:G3 standard, orthogonal frequency division multiplexing, timing synchronization, cross-correlation algorithm, channel estimation, CELENEC frequency bands
基金项目:国家自然科学基金项目(面上项目,重点项目,重大项目);中国博士后科学基金;江苏高校优势学科建设工程
  
作者中文名作者英文名单位
王荣军wang rongjun南京航空航天大学
摘要点击次数: 1941
中文摘要:
      由于低压电力线在传输信号过程中受到噪声、多径干扰和频率选择性衰落等影响,造成定时同步不准确,容易产生漏检和误判。针对G3-PLC标准,本文提出了一种定时同步和信道估计联合设计方案,通过与本地序列进行两级互相关来实现符号的定时同步,并利用相关器输出直接进行信道估计。该方案提高了定时同步的精度,扩大了其正常工作的信噪比范围,并且简化了信道估计实现方案。最后完成了联合设计的硬件实现,利用FFT计算互相关,有效降低了计算量,减少了硬件资源开销,同时实现了多种CELENEC频段传输模式兼容。
英文摘要:
      Since low voltage power lines are affected by noise pollution, multi-path propagation and frequency selective fading in the process of signal transmission. It results in inaccuracy of timing synchronization, leak detection and misjudgment. A combined design scheme of timing synchronization and channel estimations proposed in this paper under the G3-PLC standard. Firstly, second-order cross-correlation with the local pilot is acquired to realize timing synchronization. Then the output of the correlator is used directly to achieve channel estimation. This design scheme improves the accuracy of timing synchronization and expands the range of SNR in normal work. Besides it simplifies the scheme of channel estimation. At last the hardware of the combined design scheme is accomplished. It uses FFT to calculated cross-correlation, which effectively reduces the computation and the amount of hardware resources. Meanwhile, compatible transmission mode of various CELENEC band is brought out.
查看全文  查看/发表评论  下载PDF阅读器
关闭
  • 哈尔滨电工仪表研究所有限公司
  • 中国电工仪器仪表信息网
  • 中国仪器仪表学会
  • 中华人民共和国新闻出版总署
  • 中国科技期刊编辑学会
  • 黑龙江省科学技术协会
  • 编辑之家
  • 中国知网
  • 万方数据库
  • 维普网
  • 北极星电力网
  • 中华中控网
  • 网站首页
  • 期刊介绍
    • 期刊简介
    • 历任主编
    • 期刊荣誉
  • 编委会
    • 社长及主编
    • 主任委员
    • 编委名单
  • 投稿指南
    • 作者须知
    • 投稿步骤
    • 范文(规范细则)
    • 稿件处理流程
    • 著作权转让协议
  • 期刊影响力
  • 开放获取
  • 出版道德政策
    • 出版伦理声明
    • 学术不端认定和处理方法
    • 广告及市场推广
    • 同行评议流程
    • 斟误和撤回
    • 回避制度
    • 文章署名及版权转让
  • 历年目次
  • 联系我们
地址:哈尔滨市松北区创新路2000号    邮编:150028
邮箱:dcyb@vip.163.com    电话:0451-86611021;87186023
© 2012 电测与仪表    哈公网监备2301003445号
黑ICP备11006624号-1
技术支持:北京勤云科技发展有限公司