• 设为首页
  • 加入收藏
  • 联系邮箱
  • 网站首页
  • 期刊介绍
    • 期刊简介
    • 历任主编
    • 期刊荣誉
  • 编委会
    • 社长及主编
    • 主任委员
    • 编委名单
  • 投稿指南
    • 作者须知
    • 投稿步骤
    • 范文(规范细则)
    • 稿件处理流程
    • 著作权转让协议
  • 期刊影响力
  • 开放获取
  • 出版道德政策
    • 出版伦理声明
    • 学术不端认定和处理方法
    • 广告及市场推广
    • 同行评议流程
    • 斟误和撤回
    • 回避制度
    • 文章署名及版权转让
  • 历年目次
  • 联系我们
  • English
站内检索    
 
侯亚文,曹炜,祁晓卿,刘宁宁.(23期已送排)直流微网的一种分布式控制研究[J].电测与仪表,2017,54(24):.
HOU YaWen,CAO Wei,QI Xiaoqing,Liu Ningning.A Distributed Control Approach of DC micro-grid[J].Electrical Measurement & Instrumentation,2017,54(24):.
(23期已送排)直流微网的一种分布式控制研究
A Distributed Control Approach of DC micro-grid
DOI:
中文关键词:  直流微网  下垂控制  功率分配机制  分布式控制  功率补偿  电压补偿
英文关键词:DC microgrid  droop control  power share mechanism  distributed control  load share compensation  voltage deviation compensation
基金项目:国家高技术研究发展计划(863计划)(2011AA05A106)
           
作者中文名作者英文名单位
侯亚文HOU YaWen上海电力学院电气工程学院
曹炜CAO Wei上海电力学院电气工程学院
祁晓卿QI Xiaoqing北京电力经济技术研究院
刘宁宁Liu Ningning上海电力学院电气工程学院
摘要点击次数: 1879
中文摘要:
      针对直流微网中微源常规下垂控制方案下功率均分与电压质量不能兼顾的不足,本文考虑各微源容量不尽相同,以各微源负载率相同为功率均分目标,设计了基于低速通信的改进下垂控制方案,以功率补偿的PI控制保证功率均分,以电压补偿的PI控制保证电压质量。建立该控制方案下的多微源网状系统模型,进行了静态稳定分析。为防止可能发生的个别微源下垂系数设置不合理引发的问题,引入满载微源连锁停发功率信号的机制以保证微网系统可正常运行。在Matlab/Simulink中模拟搭建了3电源6母线直流微网系统进行了热插拔实验、下垂系数设置不合理致某一微源满载运行实验,验证了该系统在可能出现的上述工况下均能保持系统稳定、功率均分和电压质量。
英文摘要:
      The disadvantage of the conventional droop control scheme of DC micro-grid is that it should compromise between the reasonable load share and voltage regulation. In order to achieve the same load ratio among the microsources of different capacity, an improved droop control method is proposed based on the low-bandwidth communication (LBC), in which the load share accuracy and reasonable voltage deviation is achieved by load share compensation and voltage deviation compensation respectively. The multi-source DC network with the improved droop control approach is modeled to analyze its small-signal stability. The mechanism of stopping sending power signal from the over-loaded sources because of the miss setting of droop coefficients is introduced to ensure the microsystem operation. A 3-source 6 –bus DC micro grid is built in Matlab/Simulink to check the overall behavior of the proposed approach. The hot swap and the scenario of some micro sources over-loaded with others at lower load rate due to improper setting of droop coefficients is simulated. The simulations verify that the stability, the power share accuracy and the voltage deviation quality can be achieved by the proposed approach.
查看全文  查看/发表评论  下载PDF阅读器
关闭
  • 哈尔滨电工仪表研究所有限公司
  • 中国电工仪器仪表信息网
  • 中国仪器仪表学会
  • 中华人民共和国新闻出版总署
  • 中国科技期刊编辑学会
  • 黑龙江省科学技术协会
  • 编辑之家
  • 中国知网
  • 万方数据库
  • 维普网
  • 北极星电力网
  • 中华中控网
  • 网站首页
  • 期刊介绍
    • 期刊简介
    • 历任主编
    • 期刊荣誉
  • 编委会
    • 社长及主编
    • 主任委员
    • 编委名单
  • 投稿指南
    • 作者须知
    • 投稿步骤
    • 范文(规范细则)
    • 稿件处理流程
    • 著作权转让协议
  • 期刊影响力
  • 开放获取
  • 出版道德政策
    • 出版伦理声明
    • 学术不端认定和处理方法
    • 广告及市场推广
    • 同行评议流程
    • 斟误和撤回
    • 回避制度
    • 文章署名及版权转让
  • 历年目次
  • 联系我们
地址:哈尔滨市松北区创新路2000号    邮编:150028
邮箱:dcyb@vip.163.com    电话:0451-86611021;87186023
© 2012 电测与仪表    哈公网监备2301003445号
黑ICP备11006624号-1
技术支持:北京勤云科技发展有限公司