• 设为首页
  • 加入收藏
  • 联系邮箱
  • 网站首页
  • 期刊介绍
    • 期刊简介
    • 历任主编
    • 期刊荣誉
  • 编委会
    • 社长及主编
    • 主任委员
    • 编委名单
  • 投稿指南
    • 作者须知
    • 投稿步骤
    • 范文(规范细则)
    • 稿件处理流程
    • 著作权转让协议
  • 期刊影响力
  • 开放获取
  • 出版道德政策
    • 出版伦理声明
    • 学术不端认定和处理方法
    • 广告及市场推广
    • 同行评议流程
    • 斟误和撤回
    • 回避制度
    • 文章署名及版权转让
  • 历年目次
  • 联系我们
  • English
站内检索    
 
贾正森,王 磊,刘志尧,彭小娟,陆祖良.基于量子技术的交流电压幅值测量准确度研究[J].电测与仪表,2018,55(1):98-101.
Jia Zhengsen,Wang Lei,Liu zhiyao,Peng Xiaojuan,Lu Zuliang.The accuracy research of AC voltage amplitude measurement accuracy based on quantum technologies[J].Electrical Measurement & Instrumentation,2018,55(1):98-101.
基于量子技术的交流电压幅值测量准确度研究
The accuracy research of AC voltage amplitude measurement accuracy based on quantum technologies
DOI:
中文关键词:  差分采样  交流电压  量子电压  测量准确度  窗函数
英文关键词:Differential sampling, AC voltage, Quantum voltage, Measurement accuracy, Window function algorithm
基金项目:国家高技术研究发展计划(863计划)(2015AA050404)
              
作者中文名作者英文名单位
贾正森Jia Zhengsen中国计量科学研究院
王 磊Wang Lei中国计量科学研究院
刘志尧Liu zhiyao中国计量科学研究院
彭小娟Peng Xiaojuan北京化工大学
陆祖良Lu Zuliang中国计量科学研究院
摘要点击次数: 1641
中文摘要:
      在基于量子技术的交流信号测量中,采样是最常使用的方法,而在此方法中,差分电压的测量精度是决定交流电压幅值测量准确度的主要因素。为此,本文分析了交流量子电压台阶数、采样率和窗函数选取对测量准确度的影响。在交流量子电压不存在过渡过程的情况下,当采样率为常数时,通过改变交流量子电压的台阶个数,发现补偿后的相对误差随着台阶个数增加而减小;当交流量子电压的台阶个数为常数时,通过改变采样率,发现补偿后的相对误差随着采样率的提高而减小。在过渡过程和噪声干扰均存在的情况下,采用增加窗函数处理后,有效地提高了测量准确度。
英文摘要:
      Based on quantum technologies to measure alternative current (AC) signal, sampling is the most commonly used method. In this method, the measurement accuracy of AC voltage amplitude depends mainly on measurement accuracy of differential signal. Therefore, in this paper, impact on measurement accuracy, quantum AC voltage steps, sample rate and window function, are analysed. Without transient process, it is observed that the relative error after compensation decreases with the increasing number of steps in case of sampling rate is constant. Similarity, when the steps of Quantum AC voltage remain the same, it shows that the relative error after compensation decreases with the increasing number of sampling rate. With transient process and noise interference, the measurement accuracy has been significantly improved by increasing the window function.
查看全文  查看/发表评论  下载PDF阅读器
关闭
  • 哈尔滨电工仪表研究所有限公司
  • 中国电工仪器仪表信息网
  • 中国仪器仪表学会
  • 中华人民共和国新闻出版总署
  • 中国科技期刊编辑学会
  • 黑龙江省科学技术协会
  • 编辑之家
  • 中国知网
  • 万方数据库
  • 维普网
  • 北极星电力网
  • 中华中控网
  • 网站首页
  • 期刊介绍
    • 期刊简介
    • 历任主编
    • 期刊荣誉
  • 编委会
    • 社长及主编
    • 主任委员
    • 编委名单
  • 投稿指南
    • 作者须知
    • 投稿步骤
    • 范文(规范细则)
    • 稿件处理流程
    • 著作权转让协议
  • 期刊影响力
  • 开放获取
  • 出版道德政策
    • 出版伦理声明
    • 学术不端认定和处理方法
    • 广告及市场推广
    • 同行评议流程
    • 斟误和撤回
    • 回避制度
    • 文章署名及版权转让
  • 历年目次
  • 联系我们
地址:哈尔滨市松北区创新路2000号    邮编:150028
邮箱:dcyb@vip.163.com    电话:0451-86611021;87186023
© 2012 电测与仪表    哈公网监备2301003445号
黑ICP备11006624号-1
技术支持:北京勤云科技发展有限公司