• 设为首页
  • 加入收藏
  • 联系邮箱
  • 网站首页
  • 期刊介绍
    • 期刊简介
    • 历任主编
    • 期刊荣誉
  • 编委会
    • 社长及主编
    • 主任委员
    • 编委名单
  • 投稿指南
    • 作者须知
    • 投稿步骤
    • 范文(规范细则)
    • 稿件处理流程
    • 著作权转让协议
  • 期刊影响力
  • 开放获取
  • 出版道德政策
    • 出版伦理声明
    • 学术不端认定和处理方法
    • 广告及市场推广
    • 同行评议流程
    • 斟误和撤回
    • 回避制度
    • 文章署名及版权转让
  • 历年目次
  • 联系我们
  • English
站内检索    
 
袁晓敏,袁旭峰,李婧.城市配电网柔性互联系统故障重构研究[J].电测与仪表,2018,55(20):76-81.
YUAN Xiaomin,YUAN Xufeng,LI jing.Research on fault reconstruction of flexible interconnected system of urban distribution network[J].Electrical Measurement & Instrumentation,2018,55(20):76-81.
城市配电网柔性互联系统故障重构研究
Research on fault reconstruction of flexible interconnected system of urban distribution network
DOI:
中文关键词:  柔性电力电子开关(SNOP)  配电网  故障重构  二进制粒子群算法(BPSO)
英文关键词:Soft normally open point (SNOP), distribution systems, reconstruction after faults, binary particle swarm optimization (BPSO)
基金项目:国家自然科学基金项目( 重点项目);中国南方电网有限责任公司重点科技项目
        
作者中文名作者英文名单位
袁晓敏YUAN Xiaomin贵州大学电气工程学院
袁旭峰YUAN Xufeng贵州大学电气工程学院
李婧LI jing贵州大学电气工程学院
摘要点击次数: 1570
中文摘要:
      柔性电力电子开关(soft normally open point,SNOP)用于替代传统配电网中的联络开关,文中对SNOP单侧交流系统故障后进行恢复重构研究。SNOP在配电网故障后可提供电压支撑作用,在配电网故障恢复重构研究时,除了要考虑系统运行约束条件外,还需考虑SNOP的运行特性。文中首先建立了SNOP的潮流稳态模型;通过牛拉法潮流计算去掉不符合系统运行约束条件的开关组合;然后以二进制粒子群算法(binary particle swarm optimization,BPSO)为基础,建立以重要失电负荷最少、网损最小、开关操作数最少为目标函数,设置潮流、电压、电流等约束条件,寻求故障重构的最优开关组合。最后以两个IEEE33节点算例互联为例用matlab仿真,验证所建立模型和算法的可行性。
英文摘要:
      Soft normally open point (SNOP) are used to replace contact switches in traditional distribution systems. In this paper, the reconstruction of SNOP unilateral AC system is studied. SNOP can provide the voltage support function after the fault of the distribution network. In the study of the reconfiguration of the distribution network, the operation characteristic of SNOP should be considered besides considering the operating constraints of the system. The paper first presents a trend of steady state model of SNOP; the ox drawn flow calculation method to remove the combination switch does not meet the system operation constraints; Then, based on the binary particle swarm optimization (BPSO), the objective function is to minimize the critical loss, minimize the load loss and minimize the switching operation, setting the constraints of power flow, voltage and current, which is to find the optimal switch combination for fault reconstruction. Finally, two IEEE33 nodes are taken as examples, and the feasibility of the model and algorithm is verified by MATLAB simulation.
查看全文  查看/发表评论  下载PDF阅读器
关闭
  • 哈尔滨电工仪表研究所有限公司
  • 中国电工仪器仪表信息网
  • 中国仪器仪表学会
  • 中华人民共和国新闻出版总署
  • 中国科技期刊编辑学会
  • 黑龙江省科学技术协会
  • 编辑之家
  • 中国知网
  • 万方数据库
  • 维普网
  • 北极星电力网
  • 中华中控网
  • 网站首页
  • 期刊介绍
    • 期刊简介
    • 历任主编
    • 期刊荣誉
  • 编委会
    • 社长及主编
    • 主任委员
    • 编委名单
  • 投稿指南
    • 作者须知
    • 投稿步骤
    • 范文(规范细则)
    • 稿件处理流程
    • 著作权转让协议
  • 期刊影响力
  • 开放获取
  • 出版道德政策
    • 出版伦理声明
    • 学术不端认定和处理方法
    • 广告及市场推广
    • 同行评议流程
    • 斟误和撤回
    • 回避制度
    • 文章署名及版权转让
  • 历年目次
  • 联系我们
地址:哈尔滨市松北区创新路2000号    邮编:150028
邮箱:dcyb@vip.163.com    电话:0451-86611021;87186023
© 2012 电测与仪表    哈公网监备2301003445号
黑ICP备11006624号-1
技术支持:北京勤云科技发展有限公司