• 设为首页
  • 加入收藏
  • 联系邮箱
  • 网站首页
  • 期刊介绍
    • 期刊简介
    • 历任主编
    • 期刊荣誉
  • 编委会
    • 社长及主编
    • 主任委员
    • 编委名单
  • 投稿指南
    • 作者须知
    • 投稿步骤
    • 范文(规范细则)
    • 稿件处理流程
    • 著作权转让协议
  • 期刊影响力
  • 开放获取
  • 出版道德政策
    • 出版伦理声明
    • 学术不端认定和处理方法
    • 广告及市场推广
    • 同行评议流程
    • 斟误和撤回
    • 回避制度
    • 文章署名及版权转让
  • 历年目次
  • 联系我们
  • English
站内检索    
 
刘溟,张锡洋,邹建明,杨伟敏,周文俊,喻剑辉.三维定位方法在变电站局部放电检测中的应用[J].电测与仪表,2019,56(5):111-118.
Liu Ming,Zhang Xiyang,Zou Jianming,Yang Weimin,Zhou Wenjun,Yu Jianhui.Application of Three Dimensional Location Method of Partial Discharge Detection in Substation[J].Electrical Measurement & Instrumentation,2019,56(5):111-118.
三维定位方法在变电站局部放电检测中的应用
Application of Three Dimensional Location Method of Partial Discharge Detection in Substation
DOI:
中文关键词:  局部放电  多方位检测  三维定位  LabVIEW
英文关键词:partial  discharge, multi-direction  measurement, three-dimensional  location, LabVIEW
基金项目:
                 
作者中文名作者英文名单位
刘溟Liu Ming国家电网公司华中分部
张锡洋Zhang Xiyang武汉大学电气工程学院
邹建明Zou Jianming国家电网公司华中分部
杨伟敏Yang Weimin武汉大学电气工程学院
周文俊Zhou Wenjun武汉大学电气工程学院
喻剑辉Yu Jianhui武汉大学电气工程学院
摘要点击次数: 1306
中文摘要:
      针对当前变电站局部放电定位系统仅能实现准确的局部放电(PD)二维定位,开展了三维定位方法在变电站PD检测中的应用研究。本文采用定向天线的PD多方位检测定位方法,采取在多个检测点旋转两支特高频定向天线的检测模式,利用不同旋转角度下局放源到达两支天线的不同时延求解定位方程组实现PD三维定位。为实现该方法的现场应用设计了一套局部放电三维定位系统,系统通过各硬件进行角度、时延、定位坐标等参数的采集并传输至上位机,然后在基于LabVIEW平台开发的上位机软件中进行PD源三维坐标计算、显示并保存计算结果。最后,通过试验验证了该系统的有效性,试验结果表明,该系统的PD三维定位偏差不超过0.4米,远优于二维定位精度。
英文摘要:
      In view of the current partial discharge(PD) location system of the substation, only accurate two-dimensional location can be achieved, the application of three-dimensional location method in PD detection of substation is studied. This paper uses multi-direction measurement and location method of PD based on directional antenna, which adopts detection mode rotating two ultra high frequency directional antennas in multiple detection points, using different time delay of the antennas under different rotation angles to solve equations for the three-dimensional PD source localization. In order to realize the field application of this method, a set of three-dimensional PD location system is designed. The system acquisitions parameters like angle、time delay、coordinates of the system and transmits them to host computer. Then the three-dimensional coordinate of PD source is calculated in the host computer software based on LabVIEW, the results are also displayed and saved by the software. Finally, the effectiveness of the system is verified by experiments. The results show that the three-dimensional location deviation of the PD source is not more than 0.4 meters, which is much better than two-dimensional location accuracy.
查看全文  查看/发表评论  下载PDF阅读器
关闭
  • 哈尔滨电工仪表研究所有限公司
  • 中国电工仪器仪表信息网
  • 中国仪器仪表学会
  • 中华人民共和国新闻出版总署
  • 中国科技期刊编辑学会
  • 黑龙江省科学技术协会
  • 编辑之家
  • 中国知网
  • 万方数据库
  • 维普网
  • 北极星电力网
  • 中华中控网
  • 网站首页
  • 期刊介绍
    • 期刊简介
    • 历任主编
    • 期刊荣誉
  • 编委会
    • 社长及主编
    • 主任委员
    • 编委名单
  • 投稿指南
    • 作者须知
    • 投稿步骤
    • 范文(规范细则)
    • 稿件处理流程
    • 著作权转让协议
  • 期刊影响力
  • 开放获取
  • 出版道德政策
    • 出版伦理声明
    • 学术不端认定和处理方法
    • 广告及市场推广
    • 同行评议流程
    • 斟误和撤回
    • 回避制度
    • 文章署名及版权转让
  • 历年目次
  • 联系我们
地址:哈尔滨市松北区创新路2000号    邮编:150028
邮箱:dcyb@vip.163.com    电话:0451-86611021;87186023
© 2012 电测与仪表    哈公网监备2301003445号
黑ICP备11006624号-1
技术支持:北京勤云科技发展有限公司