• 设为首页
  • 加入收藏
  • 联系邮箱
  • 网站首页
  • 期刊介绍
    • 期刊简介
    • 历任主编
    • 期刊荣誉
  • 编委会
    • 社长及主编
    • 主任委员
    • 编委名单
  • 投稿指南
    • 作者须知
    • 投稿步骤
    • 范文(规范细则)
    • 稿件处理流程
    • 著作权转让协议
  • 期刊影响力
  • 开放获取
  • 出版道德政策
    • 出版伦理声明
    • 学术不端认定和处理方法
    • 广告及市场推广
    • 同行评议流程
    • 斟误和撤回
    • 回避制度
    • 文章署名及版权转让
  • 历年目次
  • 联系我们
  • English
站内检索    
 
王志斌,曹红伟,刘佳佳.基于小波包去噪与EMD的故障电弧检测算法研究[J].电测与仪表,2019,56(6):117-121.
wangzhibin,caohongwei,liujiajia.Research on fault arc detection algorithm based on wavelet packet noise reduction and EMD decomposition[J].Electrical Measurement & Instrumentation,2019,56(6):117-121.
基于小波包去噪与EMD的故障电弧检测算法研究
Research on fault arc detection algorithm based on wavelet packet noise reduction and EMD decomposition
DOI:
中文关键词:  故障电弧  小波包去噪  经验模态分解  故障诊断  支持向量机
英文关键词:Fault arc  Wavelet packet noise reduction  EMD  fault diagnosis  SVM
基金项目:
        
作者中文名作者英文名单位
王志斌wangzhibin燕山大学
曹红伟caohongwei燕山大学
刘佳佳liujiajia燕山大学
摘要点击次数: 2112
中文摘要:
      经验模态分解(Empirical Mode Decomposition,简称EMD)方法是一种被广泛应用于故障诊断领域的信号处理方法,但是分解的结果容易受到高频噪声的干扰。因此本文提出利用小波包去除噪声,同时利用EMD分解进行故障电弧信号处理的研究方法。首先根据国标GB/T31143—2014搭建故障电弧实验平台,采集故障电弧信号,利用小波包去除信号中的噪声,然后利用EMD方法对正常电弧和故障电弧进行分解得到一系列本征模态分量,通过计算求出这些分量的能量熵并进行归一化处理得到特征向量,最后进行支持向量机(SVM)训练,进而诊断得出故障电弧的故障类型。实验结果表明该方法可以有效准确地对故障电弧进行判断。
英文摘要:
      Empirical mode decomposition (EMD) is a signal processing method widely used in the field of fault diagnosis.It has been successfully applied in the field of fault diagnosis,But the decomposition results are easily interfered by high frequency noise.Therefore, this paper puts forward the method of using the wavelet packet to remove the noise and the fault arc signal processing by EMD decomposition.First,the fault arc experimental platform is built according to the national standard GB/T31143-2014,and the fault arc signal is collected,using wavelet packet to remove the noise in the signal, Then the EMD method is used to decompose the normal arc and the fault arc to obtain a series of IMFs,the energy entropy of these components is obtained by calculation and the eigenvectors are obtained by normalization,finally,support vector machine (SVM) training, and then the fault type arc fault diagnosis.The experimental results show that the method can effectively and accurately determine the fault arc.
查看全文  查看/发表评论  下载PDF阅读器
关闭
  • 哈尔滨电工仪表研究所有限公司
  • 中国电工仪器仪表信息网
  • 中国仪器仪表学会
  • 中华人民共和国新闻出版总署
  • 中国科技期刊编辑学会
  • 黑龙江省科学技术协会
  • 编辑之家
  • 中国知网
  • 万方数据库
  • 维普网
  • 北极星电力网
  • 中华中控网
  • 网站首页
  • 期刊介绍
    • 期刊简介
    • 历任主编
    • 期刊荣誉
  • 编委会
    • 社长及主编
    • 主任委员
    • 编委名单
  • 投稿指南
    • 作者须知
    • 投稿步骤
    • 范文(规范细则)
    • 稿件处理流程
    • 著作权转让协议
  • 期刊影响力
  • 开放获取
  • 出版道德政策
    • 出版伦理声明
    • 学术不端认定和处理方法
    • 广告及市场推广
    • 同行评议流程
    • 斟误和撤回
    • 回避制度
    • 文章署名及版权转让
  • 历年目次
  • 联系我们
地址:哈尔滨市松北区创新路2000号    邮编:150028
邮箱:dcyb@vip.163.com    电话:0451-86611021;87186023
© 2012 电测与仪表    哈公网监备2301003445号
黑ICP备11006624号-1
技术支持:北京勤云科技发展有限公司