• 设为首页
  • 加入收藏
  • 联系邮箱
  • 网站首页
  • 期刊介绍
    • 期刊简介
    • 历任主编
    • 期刊荣誉
  • 编委会
    • 社长及主编
    • 主任委员
    • 编委名单
  • 投稿指南
    • 作者须知
    • 投稿步骤
    • 范文(规范细则)
    • 稿件处理流程
    • 著作权转让协议
  • 期刊影响力
  • 开放获取
  • 出版道德政策
    • 出版伦理声明
    • 学术不端认定和处理方法
    • 广告及市场推广
    • 同行评议流程
    • 斟误和撤回
    • 回避制度
    • 文章署名及版权转让
  • 历年目次
  • 联系我们
  • English
站内检索    
 
张 强,王 勇,苟铖.基于电压补偿的低速永磁电机谐波抑制控制策略研究[J].电测与仪表,2019,56(7):113-118.
Zhang Qiang,Wang Yong,Gou Cheng.Control strategy of low-speed permanent magnet synchronous motor current harmonics suppression based on voltage compensation[J].Electrical Measurement & Instrumentation,2019,56(7):113-118.
基于电压补偿的低速永磁电机谐波抑制控制策略研究
Control strategy of low-speed permanent magnet synchronous motor current harmonics suppression based on voltage compensation
DOI:
中文关键词:  低速永磁电机  谐波  电压补偿
英文关键词:low-speed permanent magnet synchronous motor  harmonic current  voltage compensation
基金项目:国家重大科学仪器设备开发专项(2014YQ350461)
        
作者中文名作者英文名单位
张 强Zhang Qiang中国工程物理研究院 计量测试中心
王 勇Wang Yong中国工程物理研究院 计量测试中心
苟铖Gou Cheng中国工程物理研究院 计量测试中心
摘要点击次数: 1705
中文摘要:
      扭矩扳子自动化检定装置用低速永磁同步电机通常工作于300r/min以下,由于电机本体气隙磁场畸变、逆变器死区时间、开关管压降等非线性因素,电机在运行过程中会产生高次谐波,引起转矩脉动,导致加载过程中输出扭矩波动,影响检定过程。针对上述问题,提出了一种针对低速永磁电机的谐波抑制控制策略,建立了低速永磁电机的谐波数学模型,采用电压补偿的方法,根据谐波数学模型计算谐波电压补偿量,并采用PI控制,对电机运行过程中的相电流谐波进行抑制,从而减小扭矩扳子自动化检定装置的转矩脉动。通过仿真表明,该方法可以显著降低谐波,从而减小电机输出转矩脉动。
英文摘要:
      Low-speed permanent magnet synchronous motor (Low-speed PMSM) which used in torque wrench calibrating device usually works below 300 revolutions per minute. There was a lot of high order harmonic in the motor phase current due to the distortion of air-gap magnetic field, the dead-time and tube voltage drop of the inverter, which caused the torque ripple and the output torque fluctuates during loading, the measurement process was influenced. A novel harmonic suppression method for low-speed PMSM based on voltage compensation was proposed in view of this problem. The model of low-speed PMSM was established considering the existence of current harmonics. The method of voltage compensation was adopted, and harmonic compensation was calculated based on the model of low-speed PMSM. The current harmonics were compensated by PI control strategy. Simulation results show that the method based on voltage compensation can suppress the harmonic currents and reduce torque ripple effectively.
查看全文  查看/发表评论  下载PDF阅读器
关闭
  • 哈尔滨电工仪表研究所有限公司
  • 中国电工仪器仪表信息网
  • 中国仪器仪表学会
  • 中华人民共和国新闻出版总署
  • 中国科技期刊编辑学会
  • 黑龙江省科学技术协会
  • 编辑之家
  • 中国知网
  • 万方数据库
  • 维普网
  • 北极星电力网
  • 中华中控网
  • 网站首页
  • 期刊介绍
    • 期刊简介
    • 历任主编
    • 期刊荣誉
  • 编委会
    • 社长及主编
    • 主任委员
    • 编委名单
  • 投稿指南
    • 作者须知
    • 投稿步骤
    • 范文(规范细则)
    • 稿件处理流程
    • 著作权转让协议
  • 期刊影响力
  • 开放获取
  • 出版道德政策
    • 出版伦理声明
    • 学术不端认定和处理方法
    • 广告及市场推广
    • 同行评议流程
    • 斟误和撤回
    • 回避制度
    • 文章署名及版权转让
  • 历年目次
  • 联系我们
地址:哈尔滨市松北区创新路2000号    邮编:150028
邮箱:dcyb@vip.163.com    电话:0451-86611021;87186023
© 2012 电测与仪表    哈公网监备2301003445号
黑ICP备11006624号-1
技术支持:北京勤云科技发展有限公司