• 设为首页
  • 加入收藏
  • 联系邮箱
  • 网站首页
  • 期刊介绍
    • 期刊简介
    • 历任主编
    • 期刊荣誉
  • 编委会
    • 社长及主编
    • 主任委员
    • 编委名单
  • 投稿指南
    • 作者须知
    • 投稿步骤
    • 范文(规范细则)
    • 稿件处理流程
    • 著作权转让协议
  • 期刊影响力
  • 开放获取
  • 出版道德政策
    • 出版伦理声明
    • 学术不端认定和处理方法
    • 广告及市场推广
    • 同行评议流程
    • 斟误和撤回
    • 回避制度
    • 文章署名及版权转让
  • 历年目次
  • 联系我们
  • English
站内检索    
 
赖俊驹,彭浩,姜昀芃,胡金磊,黄石华,王文博.不拆解接地线的GIS导电回路电阻快速测量方法研究[J].电测与仪表,2019,56(15):113-118.
赖俊驹,彭浩,Jiang Yunpeng,胡金磊,黄石华,王文博.Research on fast measuring method of GIS circuit resistance without removing grounding wire[J].Electrical Measurement & Instrumentation,2019,56(15):113-118.
不拆解接地线的GIS导电回路电阻快速测量方法研究
Research on fast measuring method of GIS circuit resistance without removing grounding wire
DOI:10.19753/j.issn1001-1390.2019.015.017
中文关键词:  接地线  GIS  导电回路电阻  测量方法  阻抗网络
英文关键词:Grounding wire, GIS, Circuit resistance, Measuring method, Impedance network
基金项目:广东电网有限责任公司科技创新项目(GDKJXM20162171)
                 
作者中文名作者英文名单位
赖俊驹赖俊驹
彭浩彭浩
姜昀芃Jiang Yunpeng华中科技大学
胡金磊胡金磊
黄石华黄石华
王文博王文博
摘要点击次数: 1577
中文摘要:
      GIS设备在安装及检修过程中,需要利用直流压降法来检测导电回路电阻,以检查断路器、隔离开关等设备的连接状况。但是,直流压降法在测量时需要拆解接地线,其操作繁琐、工作效率低。同时,还存在损伤本体结构,以及从周围带电设备感应出高电压的可能。为此,本文基于GIS设备的拓扑结构,提出了一种不拆解接地线的GIS导电回路电阻快速测量方法。该方法首先将GIS网络提取成多阶T型阻抗网络,通过节点电压方程和回路电流方程建立对应的阻抗矩阵。通过施加两次不同接线方案的直流激励源来求解该阻抗矩阵。同时,本文还分析了接地网络分流和三相相间分流对测量结果的影响,并在此基础上提出了该方法的激励源施加方案。经实例验证,该方法的测量结果与直流压降法的测量结果相似,同时还可有效提高工作效率,对同类型GIS设备的导电回路电阻测量具有参考意义。
英文摘要:
      During the installation and maintenance of GIS equipment, DC voltage drop method is needed to measure the resistance of the GIS circuit in order to check the connection status of circuit breaker, disconnecting switch and other equipment. However, DC voltage drop method needs to remove the grounding wire when measuring, which is cumbersome and inefficient. At the same time, this method may damage the structure of GIS equipment and induce high voltage from the surrounding charged equipment. Therefore, based on the topology of GIS equipment, a fast measuring method of GIS circuit resistance without removing the grounding wire was proposed in this paper. The GIS network was extracted into a multilevel T-type impedance network, and the corresponding impedance matrix was established through the node voltage equation and the loop current equation. The impedance matrix is solved by applying DC excitation sources of two kinds of wiring schemes. And the influences of earth network shunting and three-phase interphase shunting on the measurement were analyzed, and on this basis, the scheme of applying excitation source was proposed. After validating, the measurement results of proposed method were similar to DC voltage drop method. This method can improve working efficiency. It has reference significance for measuring circuit resistance of the same type of GIS equipment.
查看全文  查看/发表评论  下载PDF阅读器
关闭
  • 哈尔滨电工仪表研究所有限公司
  • 中国电工仪器仪表信息网
  • 中国仪器仪表学会
  • 中华人民共和国新闻出版总署
  • 中国科技期刊编辑学会
  • 黑龙江省科学技术协会
  • 编辑之家
  • 中国知网
  • 万方数据库
  • 维普网
  • 北极星电力网
  • 中华中控网
  • 网站首页
  • 期刊介绍
    • 期刊简介
    • 历任主编
    • 期刊荣誉
  • 编委会
    • 社长及主编
    • 主任委员
    • 编委名单
  • 投稿指南
    • 作者须知
    • 投稿步骤
    • 范文(规范细则)
    • 稿件处理流程
    • 著作权转让协议
  • 期刊影响力
  • 开放获取
  • 出版道德政策
    • 出版伦理声明
    • 学术不端认定和处理方法
    • 广告及市场推广
    • 同行评议流程
    • 斟误和撤回
    • 回避制度
    • 文章署名及版权转让
  • 历年目次
  • 联系我们
地址:哈尔滨市松北区创新路2000号    邮编:150028
邮箱:dcyb@vip.163.com    电话:0451-86611021;87186023
© 2012 电测与仪表    哈公网监备2301003445号
黑ICP备11006624号-1
技术支持:北京勤云科技发展有限公司