• 设为首页
  • 加入收藏
  • 联系邮箱
  • 网站首页
  • 期刊介绍
    • 期刊简介
    • 历任主编
    • 期刊荣誉
  • 编委会
    • 社长及主编
    • 主任委员
    • 编委名单
  • 投稿指南
    • 作者须知
    • 投稿步骤
    • 范文(规范细则)
    • 稿件处理流程
    • 著作权转让协议
  • 期刊影响力
  • 开放获取
  • 出版道德政策
    • 出版伦理声明
    • 学术不端认定和处理方法
    • 广告及市场推广
    • 同行评议流程
    • 斟误和撤回
    • 回避制度
    • 文章署名及版权转让
  • 历年目次
  • 联系我们
  • English
站内检索    
 
杨国涛,卓小飞,袁新喜,方斯顿.基于虚拟DSP的变电站激光自校验技术研究[J].电测与仪表,2020,57(9):40-44.
Yang Guotao,zhuoxiaofei,yuanxinxi,fangsidun.Laser self-calibration technology of substation based on virtual DSP[J].Electrical Measurement & Instrumentation,2020,57(9):40-44.
基于虚拟DSP的变电站激光自校验技术研究
Laser self-calibration technology of substation based on virtual DSP
DOI:10.19753/j.issn1001-1390.2020.09.006
中文关键词:  虚拟DSP  激光自校验  技术研究
英文关键词:virtual  DSP, laser  self-calibration, technical  research
基金项目:
           
作者中文名作者英文名单位
杨国涛Yang Guotao国网安徽六安供电公司
卓小飞zhuoxiaofei国网安徽六安供电公司
袁新喜yuanxinxi国网安徽六安供电公司
方斯顿fangsidun南洋理工大学 新加坡
摘要点击次数: 2174
中文摘要:
      目前激光自校验是变电站自校验的重要方式,但由于变电站激光自校验存在运行成本高,使用寿命短等缺点,难以广泛使用。针对这一类问题,提出了一种基于虚拟DSP的变电站激光自校验技术。它首先通过虚拟定时中断实时接收变电站调节电压模块接收的操作命令和编写的虚拟DSP数据,利用加减速处理器改善变电站电流稳定性,利用定时插补程序提高变电站电压的定时准确度。通过插补后的动态坐标和刷新后的变电站数字信号形成映射,由此完成变电站激光自校验,降低变电站激光自校验成本,提高变电站电压稳定性。仿真实验结果表明:所提方法运行成本低,实用效果较好。
英文摘要:
      At present, the laser self-calibration is an important way of self calibration in substation, but it is difficult to be widely used because of its high cost and short service life. Aiming at this kind of problem, this paper proposes a self calibration technique based on virtual DSP in substation. It begins by virtual real time receiving substation voltage regulation module receives the command and virtual DSP data prepared by the use of acceleration and deceleration processor to improve substation current stability, using the timing interpolation procedure to enhance the substation voltage and timing accuracy. Through the dynamic coordinates of the interpolation and the mapping of the digital signal after the refresh, the self calibration of the transformer substation is completed, the laser self calibration cost is reduced, and the voltage stability of the substation is improved. The simulation results show that the proposed method has low running cost and good practical effect.
查看全文  查看/发表评论  下载PDF阅读器
关闭
  • 哈尔滨电工仪表研究所有限公司
  • 中国电工仪器仪表信息网
  • 中国仪器仪表学会
  • 中华人民共和国新闻出版总署
  • 中国科技期刊编辑学会
  • 黑龙江省科学技术协会
  • 编辑之家
  • 中国知网
  • 万方数据库
  • 维普网
  • 北极星电力网
  • 中华中控网
  • 网站首页
  • 期刊介绍
    • 期刊简介
    • 历任主编
    • 期刊荣誉
  • 编委会
    • 社长及主编
    • 主任委员
    • 编委名单
  • 投稿指南
    • 作者须知
    • 投稿步骤
    • 范文(规范细则)
    • 稿件处理流程
    • 著作权转让协议
  • 期刊影响力
  • 开放获取
  • 出版道德政策
    • 出版伦理声明
    • 学术不端认定和处理方法
    • 广告及市场推广
    • 同行评议流程
    • 斟误和撤回
    • 回避制度
    • 文章署名及版权转让
  • 历年目次
  • 联系我们
地址:哈尔滨市松北区创新路2000号    邮编:150028
邮箱:dcyb@vip.163.com    电话:0451-86611021;87186023
© 2012 电测与仪表    哈公网监备2301003445号
黑ICP备11006624号-1
技术支持:北京勤云科技发展有限公司