• 设为首页
  • 加入收藏
  • 联系邮箱
  • 网站首页
  • 期刊介绍
    • 期刊简介
    • 历任主编
    • 期刊荣誉
  • 编委会
    • 社长及主编
    • 主任委员
    • 编委名单
  • 投稿指南
    • 作者须知
    • 投稿步骤
    • 范文(规范细则)
    • 稿件处理流程
    • 著作权转让协议
  • 期刊影响力
  • 开放获取
  • 出版道德政策
    • 出版伦理声明
    • 学术不端认定和处理方法
    • 广告及市场推广
    • 同行评议流程
    • 斟误和撤回
    • 回避制度
    • 文章署名及版权转让
  • 历年目次
  • 联系我们
  • English
站内检索    
 
赵洪山,马利波,赵阳,董叶叶.基于CT的交流电源及其控制策略研究[J].电测与仪表,2020,57(15):32-39.
Zhao Hongshan,Ma Libo,Zhao Yang,Dongyeye.Research on AC Power Supply Based on CT and Its Control Strategy[J].Electrical Measurement & Instrumentation,2020,57(15):32-39.
基于CT的交流电源及其控制策略研究
Research on AC Power Supply Based on CT and Its Control Strategy
DOI:10.19753/j.issn1001-1390.2020.15.006
中文关键词:  电流互感器  交流电源  高压取能  幅值调制  
英文关键词:current  transformer, ac  power supply  based CT, tapping  energy from  high voltage  transmission lines, amplitude  modulation
基金项目:国家科技支撑计划项目:大型风电场智能化运行维护关键技术研究及示范(2015BAA06B03)
           
作者中文名作者英文名单位
赵洪山Zhao Hongshan华北电力大学 电气与电子工程学院
马利波Ma Libo华北电力大学 电气与电子工程学院
赵阳Zhao Yang华北电力大学 电气与电子工程学院
董叶叶Dongyeye华北电力大学 电气与电子工程学院
摘要点击次数: 1681
中文摘要:
      针对目前高压线路在线监测装置供电难的问题,本文基于电流互感器的电流-电压变换原理建立了一种可为变负载供电的交流电源模型。首先采用一个三绕组电流互感器,通过电力电子设备来控制第三辅助绕组的状态。当辅助绕组短路时,铁芯饱和使得负载绕组输出电压为零;当辅助绕组开路时,负载绕组输出电压恢复,从而对负载绕组输出电压起到幅值调制的作用。然后,设计了稳压反馈控制电路与基于多项式最小二乘曲线拟合函数法的稳压控制器算法,解决了在一次侧电流和所带负荷发生变化时,输出电压不稳定的问题,使负载及电流在一定范围内变化时输出电压能保持稳定。最后,通过Matlab/Simulink仿真平台验证了在可变负载情况下,所提出的基于CT交流电源有着良好的稳态和暂态输出特性,并对一次侧线路产生的影响可忽略不计。
英文摘要:
      For the power supply problem of monitoring devices on long distance high-voltage transmission lines, this paper constructs an implementation framework of AC power source based on the current transformer (CT). First, the current transformer adding the third auxiliary winding is adopted in framework, and the power electronic circuit and a new control algorithm are used to control the state change of the third auxiliary winding, that is, when the auxiliary winding is shorted, the CT load winding voltage is zero, while the auxiliary winding is open, the CT load winding voltage output is recovered, so this control strategy modulates the amplitude of the designed power source output voltage. Then, a controller was designed for stabilizing power source output voltage and a new control algorithm considered the excitation nonlinearity of CT was proposed based on the least-squares curve fitting method. Finally, based on the simulation model established with Matlab/Simulink, the feasibility of designed AC power supply was validated with stable voltage output capability in the steady and transient operation, meanwhile the paper also verified that the designed power source influence on a primary current in the transmission line can be ignored.
查看全文  查看/发表评论  下载PDF阅读器
关闭
  • 哈尔滨电工仪表研究所有限公司
  • 中国电工仪器仪表信息网
  • 中国仪器仪表学会
  • 中华人民共和国新闻出版总署
  • 中国科技期刊编辑学会
  • 黑龙江省科学技术协会
  • 编辑之家
  • 中国知网
  • 万方数据库
  • 维普网
  • 北极星电力网
  • 中华中控网
  • 网站首页
  • 期刊介绍
    • 期刊简介
    • 历任主编
    • 期刊荣誉
  • 编委会
    • 社长及主编
    • 主任委员
    • 编委名单
  • 投稿指南
    • 作者须知
    • 投稿步骤
    • 范文(规范细则)
    • 稿件处理流程
    • 著作权转让协议
  • 期刊影响力
  • 开放获取
  • 出版道德政策
    • 出版伦理声明
    • 学术不端认定和处理方法
    • 广告及市场推广
    • 同行评议流程
    • 斟误和撤回
    • 回避制度
    • 文章署名及版权转让
  • 历年目次
  • 联系我们
地址:哈尔滨市松北区创新路2000号    邮编:150028
邮箱:dcyb@vip.163.com    电话:0451-86611021;87186023
© 2012 电测与仪表    哈公网监备2301003445号
黑ICP备11006624号-1
技术支持:北京勤云科技发展有限公司