• 设为首页
  • 加入收藏
  • 联系邮箱
  • 网站首页
  • 期刊介绍
    • 期刊简介
    • 历任主编
    • 期刊荣誉
  • 编委会
    • 社长及主编
    • 主任委员
    • 编委名单
  • 投稿指南
    • 作者须知
    • 投稿步骤
    • 范文(规范细则)
    • 稿件处理流程
    • 著作权转让协议
  • 期刊影响力
  • 开放获取
  • 出版道德政策
    • 出版伦理声明
    • 学术不端认定和处理方法
    • 广告及市场推广
    • 同行评议流程
    • 斟误和撤回
    • 回避制度
    • 文章署名及版权转让
  • 历年目次
  • 联系我们
  • English
站内检索    
 
于卓琦.基于模态分析的GIS盆式绝缘子裂纹缺陷检测方法研究[J].电测与仪表,2020,57(16):23-27.
Yu Zhuoqi.Research on Crack Defect Detection Method for GIS Basin-type Insulators Based on Modal Analysis[J].Electrical Measurement & Instrumentation,2020,57(16):23-27.
基于模态分析的GIS盆式绝缘子裂纹缺陷检测方法研究
Research on Crack Defect Detection Method for GIS Basin-type Insulators Based on Modal Analysis
DOI:10.19753/j.issn1001-1390.2020.16.005
中文关键词:  盆式绝缘子  模态分析  有限元  裂纹  重根模态  振动法
英文关键词:basin-type insulator  modal analysis  finite element  crack  doublet mode  vibration method
基金项目:
  
作者中文名作者英文名单位
于卓琦Yu Zhuoqi东北电力大学
摘要点击次数: 1441
中文摘要:
      GIS盆式绝缘子的缺陷检测对于保障电力系统安全运行具有重要意义。振动法由于具有检测灵敏度高和无损检测等优点成为当前电力设备故障诊断研究的热点问题。为给振动法检测盆式绝缘子开裂提供理论指导,本文建立了正常或含有缺陷盆式绝缘子的三维模型,采用有限元法计算了盆式绝缘子在不同气室压力和不同裂纹大小时的模态频率。研究结果表明,当盆式绝缘子无裂纹时,绝缘子会出现重根模态,而当盆式绝缘子有裂纹时,绝缘子没有重根模态。当盆式绝缘子下表面压力较小时,与两侧气室压力相同时相比,模态频率呈下降趋势,而当盆式绝缘子上表面压力较小时,模态频率呈增加趋势。盆式绝缘子存在裂纹时,模态频率呈下降趋势,随着裂纹深度的增加,模态频率下降幅度也会增大。计算结果表明采用振动法检测盆式绝缘子机械状况具有可行性。
英文摘要:
      It is of importance to monitoring defects of GIS basin-type insulators for guaranteeing the security operation of power systems. The vibration method becomes a research hot topic in fault diagnosis of electrical equipment due to its high sensitivity and nondestructive test. In order to provide theoretical basis for the vibration methods, three dimensional models of normal or defective insulators are established in this paper, and modal frequencies of insulators are calculated based on the finite element method under different chamber pressures and different crack sizes. It is shown that doublet modes occur when there are no cracks in basin-type insulators, but there are no doublet modes for insulators with cracks. When compared with the condition that the chamber pressures of both surfaces are the same, the modal frequencies decrease as the chamber pressures of lower surfaces decrease, and the modal frequencies increase as the chamber pressures of upper surfaces decrease. When there are cracks in basin-type insulators, the modal frequencies decrease, and with the increase of the depth of cracks, the decline ranges of modal frequencies increase. These simulation results will no doubt prove the feasibility of using the vibration method to monitor the mechanical condition of basin-type insulators.
查看全文  查看/发表评论  下载PDF阅读器
关闭
  • 哈尔滨电工仪表研究所有限公司
  • 中国电工仪器仪表信息网
  • 中国仪器仪表学会
  • 中华人民共和国新闻出版总署
  • 中国科技期刊编辑学会
  • 黑龙江省科学技术协会
  • 编辑之家
  • 中国知网
  • 万方数据库
  • 维普网
  • 北极星电力网
  • 中华中控网
  • 网站首页
  • 期刊介绍
    • 期刊简介
    • 历任主编
    • 期刊荣誉
  • 编委会
    • 社长及主编
    • 主任委员
    • 编委名单
  • 投稿指南
    • 作者须知
    • 投稿步骤
    • 范文(规范细则)
    • 稿件处理流程
    • 著作权转让协议
  • 期刊影响力
  • 开放获取
  • 出版道德政策
    • 出版伦理声明
    • 学术不端认定和处理方法
    • 广告及市场推广
    • 同行评议流程
    • 斟误和撤回
    • 回避制度
    • 文章署名及版权转让
  • 历年目次
  • 联系我们
地址:哈尔滨市松北区创新路2000号    邮编:150028
邮箱:dcyb@vip.163.com    电话:0451-86611021;87186023
© 2012 电测与仪表    哈公网监备2301003445号
黑ICP备11006624号-1
技术支持:北京勤云科技发展有限公司