• 设为首页
  • 加入收藏
  • 联系邮箱
  • 网站首页
  • 期刊介绍
    • 期刊简介
    • 历任主编
    • 期刊荣誉
  • 编委会
    • 社长及主编
    • 主任委员
    • 编委名单
  • 投稿指南
    • 作者须知
    • 投稿步骤
    • 范文(规范细则)
    • 稿件处理流程
    • 著作权转让协议
  • 期刊影响力
  • 开放获取
  • 出版道德政策
    • 出版伦理声明
    • 学术不端认定和处理方法
    • 广告及市场推广
    • 同行评议流程
    • 斟误和撤回
    • 回避制度
    • 文章署名及版权转让
  • 历年目次
  • 联系我们
  • English
站内检索    
 
周红斌,周万竣,张小波.变电站电流互感器二次侧极性检测方案设计的研究[J].电测与仪表,2020,57(18):83-89.
Zhou Hongbin,Zhou Wanjun,Zhang Xiaobo.Research on new intelligent detection technology of secondary side polarity of CT[J].Electrical Measurement & Instrumentation,2020,57(18):83-89.
变电站电流互感器二次侧极性检测方案设计的研究
Research on new intelligent detection technology of secondary side polarity of CT
DOI:10.19753/j.issn1001-1390.2020.18.014
中文关键词:  电流互感器  极性分析  方案设计  一次侧激励电源  二次侧手持终端  检测
英文关键词:CT, secondary  side polarity, primary  side exciting  power supply, plan  design, secondary  side handheld  terminal, detection
基金项目:便携式CT极性自动检验装置的研究与应用
        
作者中文名作者英文名单位
周红斌Zhou Hongbin中国南方电网调峰调频发电公司天生桥二级水力发电有限公司
周万竣Zhou Wanjun中国南方电网调峰调频发电公司天生桥二级水力发电有限公司
张小波Zhang Xiaobo华中科技大学
摘要点击次数: 1158
中文摘要:
      继电保护大修技改后,均需对保护用CT极性及二次回路接线进行检验,其传统的检验方法为一次通流法,但其存在以下问题:工作在稳态模式下,只能校验多个CT之间的极性的相互关系,无法判断单个CT的极性的正确性。鉴于此,本文提出了一种极性检测方案设计,对500kV变电站内500kV电压等级的电流互感器二次侧极性进行分析,将一次侧的激励电源与二次侧的手持终端分离开,从而使极性的检测效果免受检测距离因素的影响,并对二次侧手持终端上的信号采集系统进行了调整,使其能够在现场众多的复杂环境下顺利完成数据采集工作,极大地缩减了设备检修时间并有效保护操作人员的人身安全。通过在现场开展极性测试分析试验,验证了检测技术的可行性及有效性,现场试验结果表明该检测系统能够准确反映极性错误,且与理论分析的结果吻合。
英文摘要:
      After the technical protection of relay protection overhaul, it is necessary to test the CT polarity and secondary circuit wiring for protection. The traditional inspection method is a one-pass method. The traditional one-pass method has the following problems: In the steady state mode, only the relationship between the polarities of multiple CTs can be checked, and the correctness of the polarity of a single CT cannot be judged. According to the principle, this paper analyzes the polarity of the secondary side of 500kV current transformer in 500kV substation and propose the plan design solution, which separates the primary side excitation power supply from the secondary side handheld terminal, so that the polarity detection effect is protected from the detection distance factor and the secondary side The signal acquisition system on the handheld terminal has been adjusted to enable it to successfully complete data collection in a variety of complex environments, greatly reducing equipment maintenance time and effectively protecting the operator"s personal safety. The feasibility and effectiveness of the detection technology were verified by conducting polar test analysis experiments on site. The field test results show that the detection system can accurately reflect the polarity error and is consistent with the theoretical analysis..
查看全文  查看/发表评论  下载PDF阅读器
关闭
  • 哈尔滨电工仪表研究所有限公司
  • 中国电工仪器仪表信息网
  • 中国仪器仪表学会
  • 中华人民共和国新闻出版总署
  • 中国科技期刊编辑学会
  • 黑龙江省科学技术协会
  • 编辑之家
  • 中国知网
  • 万方数据库
  • 维普网
  • 北极星电力网
  • 中华中控网
  • 网站首页
  • 期刊介绍
    • 期刊简介
    • 历任主编
    • 期刊荣誉
  • 编委会
    • 社长及主编
    • 主任委员
    • 编委名单
  • 投稿指南
    • 作者须知
    • 投稿步骤
    • 范文(规范细则)
    • 稿件处理流程
    • 著作权转让协议
  • 期刊影响力
  • 开放获取
  • 出版道德政策
    • 出版伦理声明
    • 学术不端认定和处理方法
    • 广告及市场推广
    • 同行评议流程
    • 斟误和撤回
    • 回避制度
    • 文章署名及版权转让
  • 历年目次
  • 联系我们
地址:哈尔滨市松北区创新路2000号    邮编:150028
邮箱:dcyb@vip.163.com    电话:0451-86611021;87186023
© 2012 电测与仪表    哈公网监备2301003445号
黑ICP备11006624号-1
技术支持:北京勤云科技发展有限公司