• 设为首页
  • 加入收藏
  • 联系邮箱
  • 网站首页
  • 期刊介绍
    • 期刊简介
    • 历任主编
    • 期刊荣誉
  • 编委会
    • 社长及主编
    • 主任委员
    • 编委名单
  • 投稿指南
    • 作者须知
    • 投稿步骤
    • 范文(规范细则)
    • 稿件处理流程
    • 著作权转让协议
  • 期刊影响力
  • 开放获取
  • 出版道德政策
    • 出版伦理声明
    • 学术不端认定和处理方法
    • 广告及市场推广
    • 同行评议流程
    • 斟误和撤回
    • 回避制度
    • 文章署名及版权转让
  • 历年目次
  • 联系我们
  • English
站内检索    
 
刘春艳,张守亮,胡元元,刘天畅,蒙丹.一种面向智能电网的交流电源失真度校准方法[J].电测与仪表,2023,60(9):138-144.
Liu Chungyan,Zhang Shouliang,Hu Yuanyuan,Liu Tianchang,Meng Dan.Calibration method for AC power supply distortion oriented to the smart grid[J].Electrical Measurement & Instrumentation,2023,60(9):138-144.
一种面向智能电网的交流电源失真度校准方法
Calibration method for AC power supply distortion oriented to the smart grid
DOI:10.19753/j.issn1001-1390.2023.09.020
中文关键词:  交流电源  校准  分流器  失真度
英文关键词:AC power supply, calibration, shunt, distortion degree
基金项目:国家自然科学基金资助项目( 61704003)
              
作者中文名作者英文名单位
刘春艳Liu Chungyan中车青岛四方机车车辆股份有限公司,山东 青岛 266000
张守亮Zhang Shouliang中车青岛四方机车车辆股份有限公司,山东 青岛 266000
胡元元Hu Yuanyuan中车青岛四方机车车辆股份有限公司,山东 青岛 266000
刘天畅Liu Tianchang中车青岛四方机车车辆股份有限公司,山东 青岛 266000
蒙丹Meng Dan中车青岛四方机车车辆股份有限公司,山东 青岛 266000
摘要点击次数: 737
中文摘要:
      智能电网面向低能耗发展要求电力系统中电源设备失真度在一定范围内。文中针对交流电源输出电流难以校准失真度的问题,结合理论推导分析失真度的影响因素,提出了一种应用分流器的交流电源校准新方法,可以显著降低校准不确定度。实验结果表明:分流器法校准交流失真度适用于更大的电流输出范围,弥补了部分功率分析仪电流量程有限的缺失,降低了失真度校准的不确定度。通过蒙特卡洛方法仿真计算分流器法由于阻值变化引起的失真度改变量,并通过不确定度理论计算,验证了分流器法在交流电源电流失真度校准方面明显的优势。不确定度从0.996%降低至0.2%,该方法可以作为面向智能电网服务的电源失真度优化校准方法,为智能电网降低噪声干扰、高效利用能源提供助力。
英文摘要:
      The low energy consumption development of smart grid requires that the power supply equipment distortion in the power system should be within a certain range. Aiming at the problem that it is difficult to calibrate the distortion degree of the output current of AC power supply, the influencing factors of the distortion are analyzed by theoretical deduction. A novel calibration method for AC power supply using a shunt is proposed, which can significantly reduce the calibration uncertainty. The experimental results show that the AC distortion degree of shunt calibration method is suitable for a larger current output range, which makes up for the limited current range of some power analyzers and reduces the uncertainty of distortion calibration. Monte Carlo method is used to simulate and calculate the distortion caused by the shunt method due to the variation of resistance value, and the uncertainty theory is used to verify the obvious advantages of the shunt method in the calibration of AC power supply current distortion. The uncertainty is reduced from 0.996% to 0.2%. This method can be used as an optimization calibration method of power distortion degree for smart grid service, which can help smart grid reduce noise interference and efficiently use energy.
查看全文  查看/发表评论  下载PDF阅读器
关闭
  • 哈尔滨电工仪表研究所有限公司
  • 中国电工仪器仪表信息网
  • 中国仪器仪表学会
  • 中华人民共和国新闻出版总署
  • 中国科技期刊编辑学会
  • 黑龙江省科学技术协会
  • 编辑之家
  • 中国知网
  • 万方数据库
  • 维普网
  • 北极星电力网
  • 中华中控网
  • 网站首页
  • 期刊介绍
    • 期刊简介
    • 历任主编
    • 期刊荣誉
  • 编委会
    • 社长及主编
    • 主任委员
    • 编委名单
  • 投稿指南
    • 作者须知
    • 投稿步骤
    • 范文(规范细则)
    • 稿件处理流程
    • 著作权转让协议
  • 期刊影响力
  • 开放获取
  • 出版道德政策
    • 出版伦理声明
    • 学术不端认定和处理方法
    • 广告及市场推广
    • 同行评议流程
    • 斟误和撤回
    • 回避制度
    • 文章署名及版权转让
  • 历年目次
  • 联系我们
地址:哈尔滨市松北区创新路2000号    邮编:150028
邮箱:dcyb@vip.163.com    电话:0451-86611021;87186023
© 2012 电测与仪表    哈公网监备2301003445号
黑ICP备11006624号-1
技术支持:北京勤云科技发展有限公司